Descriptions Of Operating Buttons - Panasonic NA-127XB1L01 Instructions Manual

Preparations before Washing
Bedding programme
Make sure that the label of each item to
be washed shows either the wash (
or
hand - wash symbol ( ).
- Wash only one blanket at a time.
Washables:
---100 % synthetic fibre b la nkets – up to
3 kg.
--- 100 % synthetic fibre futons and 100 %
cotton blankets – up to 1.5 kg (single
bed size)
--- Sheets.
--- Bedspreads.
--- 100 % synthetic fibre undersheets.
Non-washables
--- 100 % wool blankets
--- Long - piled blankets
--- Electr ic blankets (including cover)
Caution
- Before closing the door, make sure that all
laundries have been put into the inner drum
as shown in the figure to prevent the
laundries from being caught by the drum,
which may damage the laundries or the
gaskets.
14
Putting bedding into the drum
1. Fold down blanket or bedspread into a quarter of
)
their original size.
2. Put the blanket or bedspread into the drum.
Fold it while putting it into the drum (fold into 1/6
of the original size).
Both ends of blanket should face the rear of the drum.
Caution
- Do NOT roll the blanket or bedspread into
balls, or haphazardly fold them.
- This may cause excessive vibration and
damage the laundry or the appliance.
- Do not use the blanket nets. Otherwise,
spinning will fail.

Descriptions of Operating Buttons

8 7 6 5 4
1. Power Button
Press this button to power on the
washing machine. At this time, the
indicator lamp goes on. The washing
machine is shut down if you press this
button when the machine is operating.
2. Start / Pause Button
Start: press this button to start up the
washing machine after the required
program and functions have been
selected.
Pause: press this button to temporarily
disable the program during operation
of the machine. Re-press this button
to continue executing the program.
3. Program selection knob
Select an appropriate program for the
item to be washed. This enables better
washing effects.
4. Tub Clean Button
Press 【Power】and 【Tub Clean】,
and then press 【Start/Pause】to
execute the tub clean program. This
program is not enabled if the initially
selected button is not 【Tub Clean】,
【Power】
unless you press button
again and select it at first. All functional
buttons are disabled except for
【Power】button when this program
is running. Do not select selection knob
before press 【Tub Clean】.No child
lock setting and unlocking functions
are available. Therefore, you can not
pause its operation.
1
2
3
5. Preset Button
6. Water Temp Button
The default washing temperature varies
for different washing programs. This button
allows you to select the water temperature
suitable for the washing.
7. Spin Speed Button
The default spinning speed varies for
different washing programs. This button
allows you to select the spinning speed
suitable for the washing.
8. Options Button
This button allows you to select different
functional programs as needed (see P16
for details).
Spin Speed + Water Temp
To set 【Child Lock】 function, press
and hold the two functional buttons for
about 3 s after the operation started.
【 】
Child Lock function is intended
to prevent a child from touching the
control panel during washing, which
may cause changes in the program
or improper washing (see P21 for
details).
15