Preventing Frozen Water Inlet & Drain; Fault Checklist - Panasonic NA-127XB1L01 Instructions Manual

Maintenance and Care
Filter Mesh of Water lnlet Valve
- Periodically remove the water inlet hose,
and remove the dirt & stains on the filter mesh.
- To prevent water splashing, execute the
steps described below before removing
the water inlet hose.
1.Turn off the water tap.
2.Switch on the appliance.
3.Select the [Cotton] program and then
press [Start/Pause] button.
4.Turn off the washing machine after 1
minute. Water is drained from the inlet
hose.
5.Disconnect the water inlet hose and
remove it.
6.Clean the filter mesh, which is located
on the rear of the washing machine.
To do this, use a small brush, for example,
a toothbrush.
7.Re-connect the water inlet hose. Turn on
the water tap and check for leaks.
24
Preventing frozen water inlet & drain
hoses and internal connection hoses
If the washing machine is delivered in freezing
weather conditions, after setting up, leave it at
room temperature for 24 hours before using.
This will ensure that the water inlet/drain hoses
and internal connection hoses do not become
clogged up with ice.
If your water supply hose freezes, perform the
following procedures:
1.Wrap warm towels around the joints of the
water inlet hose.
Water tap
Joint
Water inlet hose
2.Add 2 to 3 liters of warm water to the drum.
( About 50 ℃ )
3.Run the [Spin] program after a dozen of
minutes.
Problem
- While washing is in progress, it can only be switched after
【 Start/Pause 】 button is pressed. If you want to change
Buttons do not work. the programme, temperature, rinse and other items after the
washing machine is started, please turn off machine and turn
on the power again.
-
Door lock may be activated.
-
Door do not open. Child lock may be activated.(See P21).
-
The water temperature or level may be too high
- Rubber parts may give off a smell when you start using the
Unusual odour
appliance, but the smell will go away over time.
Water cannot be seen
- During wash process, the Water amount used by the drum
during the wash
type washing machine is less that used by the pulsator washing
process. machine.
-
The water tap might be turned off.
No water going into -
The water inlet hose may be frozen.(
-
the appliance The water supply may be disrupted.
-
The filter mesh may be clogged.
-
Do not open the door to pour water or hot water into the drum,
otherwise water may not be stored, but may be drained out
Water is going into the
immediately.
appliance, but cannot -
If you have paused the washing and then restart it, the
appliance may drain out some water.
be stored.
-
If drain hose is removed from the fixing screw, water will not
accumulate on the drum.
Water goes into the
-
If the water level is dropped, water is automatically supplied.
appliance during the
-
For heavy loads, the water may fill up repeatedly.
wash process
Drainage during the
- After the safe water level for overflow is reached, forced
drainage will occur during the wash process.
wash process
No water flows into the
- If water exist in the drum, starts from draining.
appliance during the
rinse process
-
The display time is corrected randomly. Therefore, time pause
may occur. The displayed time is the standard time and is
The remaining time is
different from the actual needed time.
-
changed If the load is not balanced during the rinse process, operating
times will be added, and the rinse time will be extended
accordingly.

Fault Checklist

Cause
See P24).
(See P24).
25