Installation Of Drain Hose; Levelling The Washing Machine - Panasonic NA-F10MB1 Operating Instructions Manual

INSTALLATION

Installation of drain hose

1.Completely sleeve the drain hose over the sewer.
2.Fix and tighten it with a hoop.( As shown in the figure )
Warning! Warning!
• Do not twist or extend the drain hose.
• Position drain hose properly ,otherwise damage might result in water leakage.
• If drain hose is too long, do not force it into washing machine as it will cause
abnormal noises.
There are three ways to place the end of drain hose:
(If drain extension
is used)
Under 3 m

Levelling the washing machine

Warning!
• The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached
1.
the cabinet. If not, please turn them to
their original positions by tightening the
nuts.
Check alignment of the product with a
2.
spirit level and if required, correct.
3.Loosen the lock nut and turn the feet
until it is in close contacts with the floor.
4.After being locked properly, press four
corners again to make sure that they are
adjusted properly.
Under 15 cm
to
Lock nut
loosen
Raise
Lower
10
Put end of
drain hose
into floor
drain
floor drain
foot
right
lock
wrong