Cleaning The Drain Filter/Preventing A Frozen Water Supply Hose - Panasonic NA-168VX2 Operating Instructions & Installation Instructions

Maintenance
Cleaning the drain filter
Take care not to burn
yourself while handling
your clothes or touching the
inside of the drum after a
high temperature wash.
Before cleaning the drain filter, switch off
and unplug the washing machine.
1
Open and remove the drain filter cover.
Drain filter
Pump hose
2
Take the pump hose out, remove the
cap to drain the water, and put them
back to the original position after all the
water drains away. (Max 6L)

Carefully loosen the drain filter. More
water may drain out - this is normal.
4
Turn it anticlockwise, unscrew the filter
and remove it.
5
Remove any lint and debris before
carefully replacing the filter.
6
In order to return filter to where it was
1) S et filter by joining mark  of filter
and mark
2) Turn right until reach to mark  of
washer body.
28
NA-168VX2_Eng.indb 28
Cap
of washer body side.

Preventing a frozen
water supply hose
* If your washing machine is delivered
in freezing weather conditions, leave it
at room temperature for 24 hours after
you've set it up before using it. This
ensures there's no ice blocking the
water supply hose.
If your water supply hose
freezes:
1
Wrap warm towels around the
joints in the water supply hose.
Tap
Joints
Water-supply hose
2
Add two or three litres of warm
water to the drum.

Run a Drain only programme,
using the MODE button.
* Make sure you replace the filter tightly.
If it's still loose, you'll get an error
message and may not be able to use
the washing machine again until you
tighten it securely. (see page 1)
about
50°C
2010-1-26 13:05:57