Installing And Cabling The Hp Storeonce Backup System; Installing The Rail Kit; Mounting The Hp Storeonce Backup System - HP StoreOnce G3 Installation And Configuration Manual

2 Installing and cabling the HP StoreOnce Backup system

In this chapter:
Installing the rail kit (page 9)
Mounting the HP StoreOnce Backup System (page 9)
Connecting the hardware (page 11)
Connecting to the Capacity Upgrade Kit (optional) (page 13)
IMPORTANT:

Installing the rail kit

The supplied rail kits allow you to install the HP StoreOnce Backup system into square and round
hole racks for 1U and 2U servers. If mounting the HP StoreOnce Backup system into threaded hole
or telco racks, please refer to
hardware.
This installation is to be performed by qualified individuals who have knowledge of the procedures,
precautions, and hazards associated with equipment containing hazardous electrical circuits.
WARNING!
not attached to the rail by any other means. Use extreme caution when pulling the server out from
the rack; it can slip and fall, causing damage to the server or injury. HP is not responsible for any
damage or injury caused by the mishandling of the server.
WARNING!
leveling jacks (feet) extend to the floor and that the full weight of the rack rests firmly on the floor.
WARNING!
floor-bolting, anti-tip feet, ballast, or a combination of these as specified by the rack manufacturer
and applicable codes.
WARNING!
installation process. Use of the appropriate lifting device is recommended as an installation aid.
WARNING!
This makes the rack bottom-heavy and helps prevent it from becoming unstable.
WARNING!
load should not exceed 80 percent of the branch circuit rating.

Mounting the HP StoreOnce Backup system

WARNING!
installation process. Use of the appropriate lifting device is recommended as an installation aid.
1. Install the rails in the rack, as required. Follow the instructions provided separately with the
rail kits.
See also the Safety Booklet on the HP StoreOnce Backup system CD-ROM.
http://www.racksolutions.com
These rails, when installed, form only a shelf for the server to rest on. The server is
Ensure that the rack is level and stable before working on the rack. Be sure the
Ensure that the rack has anti-tip measures in place. Such measures may include
Ensure that sufficient personnel are on hand to support the product(s) during the
Always load the rack from the bottom up. Load the heaviest items in the rack first.
Do not overload the branch circuit that provides power to the rack. The total rack
Ensure that sufficient personnel are on hand to support the product(s) during the
to purchase the required mounting
Installing the rail kit 9