Ironing Tips - Telefunken HappyCare HCCV2 Instruction Manual

 Turn temperature dial to your desired setting, which is depended on the fabric of garment, refer
to IRONING TIPS latter. The soleplate starts to be heated up and the working indicator begins to
flash.
 When the working indicator changes from flashing to illuminating, it means the selected
temperature is reached and the steam is ready for ironing. Press the steam trigger to release
steam for ironing.
Note: During ironing, the temperature indicator goes on from time to time. This indicates that the iron is
heating up to the set temperature. The system may occasionally produce a pumping sound during steam
ironing. This is normal and tells you that water is pumped into the soleplate.
WARNING:
steam at people! The supply cord may become hot during a long ironing session. Do not place
the iron on a metal support when in use as it may damage the soleplate, always place the iron
on the silicone support as it's equipped with thermal insulation cushion designed to withstand
high temperature.
 During operation, if there is less water in the tank, the lack of water indicator will be illuminated,
following with two "D" sounds of buzzer. At that time, you should refill the water tank. After it,
press the reset button to reactivate the steam release function.
Note: Your steam generator has been designed to function using tap water. If your tap water is very
hard water type, we advise you to mix 50% tap water with 50% of distilled water available in most
shops. In some waterfront areas, your water salt content can be high; in this case we recommend
using only demineralized water. Always check that the water tank is properly secured in the device
after filling.
 After ironing, you can put the iron the thermal insulating cushion. If there is no steam sprayed
out from the soleplate within 8 minutes, the appliance will be turned off automatically. Remove
the plug from the wall socket. But the soleplate is still hot, never touch it with hand, place it on
the thermal insulating cushion until it cools down completely.
 And you can hold the iron in vertical position and press the steam trigger to iron hanging curtains
and clothes (jackets, suits, coats).
 The iron has an anti-drip function. If iron garments too long time, the temperature of soleplate
will decrease, the iron will stop coming out steam automatically and no water droplets can come
out from soleplate.

Ironing tips

 Always check first whether a label with ironing instructions is attached to the article. Follow
these ironing instructions in any case.
 The iron heats up quicker than cooling it down, therefore, you should start ironing the articles
requiring the lowest temperature such as those made of synthetic fiber.
 If the fabric consists of various kinds of fibers, you must always select the lowest ironing
temperature to iron the composition of those fibers.
 Silk and other fabrics that are likely to become shiny should be ironed on the inner side.
Do not touch hot soleplate at any time before cooling down! Never direct the
ENGLISH
11