Table of Contents
Advertisement
A
3.9 Settings in Automower
The product has factory settings but the settings can be
adapted to each work area.
3.9.1 Schedule
Schedule you can change the schedule settings for
In
the product. The
Schedule is set individually for each
work area connected to the charging station.
areas cannot be scheduled.
The schedule function controls which hours the product
should operate and not operate. When the product is not
operating it is parked in the charging station. The
operating hours and days can be seen in an overview in
®
the Automower
Connect app.
The default schedule setting allows the product to
operate around the clock 7 days a week. This is
normally a suitable setting for a work area
corresponding to the maximum capacity. If the work
area is less than the maximum capacity the schedule
should be used to minimize wear on the grass and to the
product.
To calculate the schedule setting, refer to
the schedule setting on page 20 .
3.9.1.1 To calculate the schedule setting
1.
Calculate the dimension of your lawn in m
2
2
2.
Divide the m
/ ft
of the lawn with the approximate
operation capacity. Refer to table below.
3.
The result is equal to the number of hours that the
product must operate each day.
Note:
The operation capacity is approximate and is
calculated for flat and open work area. If the work area
20 - Installation
has a lot of slopes or obstacles, you need to increase
Schedule settings.
the
Model
Automower
EPOS
Example: A lawn of 3000 m
Automower
3000 m
32000 ft
Days / week
7
®
Connect
3.9.2 Cutting height
The cutting height is set individually for each work area.
The cutting height can be set to 50-90 mm / 2.0-3.6 in.
3.9.3 Operation
Secondary
In the Operation's menu it is possible to change the
settings of the
cutting .
3.9.3.1 Spiral cutting
If the product enters an area where it senses the grass
is longer than average, it can change the movement
pattern to
mows in a spiral pattern to faster cut the area with
longer grass. It is possible to set the intensity of the
Spiral cutting . Very low / Low intensity means that Spiral
To calculate
cutting begins less often. High / Very high intensity
means that
Note:
2
2
/ ft
.
than 15%.
Approximate operation capaci-
ty, m
2
/h / ft
2
/h
®
550H
208 / 2240
2
/ 32000 ft
®
550H EPOS.
2
/ 208 ≈ 14.5 h.
2
/ 2240 ≈ 14.5 h.
h / day
Schedule settings
14.5
7:00 - 21:30 / 7:00 am -
9:30 pm
Weather timer, ECO mode and Spiral
Spiral cutting . This means that the product
Spiral cutting begins more often.
Spiral Cutting does not start in slopes steeper
1619 - 002 - 19.01.2021
2
, cut with an
Hide quick links:
Advertisement
Table of Contents
