Editing M20 Operating Parameters; The Keypad; A 0 Through 9 Buttons; Up Arrow/Yes/Upper Case - Alesis ADAT-M20 Owner's Manual

E
DITING
3.1 T K
HE EYPAD
The keypad block contains switches for editing the various parameters that control the M20's
features.
3.1 0
A THROUGH
Use the 10 numeric keys to enter number parameter values and letters for names. When
editing a parameter value, pressing a key enters its associated number. When editing a name,
pressing a key cycles through the letters indicated on the keycap (e.g., pressing 7 repeatedly
cycles through 7, s, t, u, v, 7, s, t...etc.).
3.1 U A
B P
This key:
Increments parameter values, as well as scrolls up through a list of parameter values.
Holding this button for 2 or more seconds increases the speed at which the values
increment. After 7 seconds, this speed increases again.
Enters "Yes" in response to Yes/No queries.
In a sign (polarity) field, selects the positive (+) sign.
In a name field, changes lower case letters to UPPER CASE.
3.1 D
C OWN
This key:
Decrements parameter values, as well as scrolls down through a list of parameter values.
Holding this button for 2 or more seconds increases the speed at which the values
decrement. After 7 seconds, this speed increases again.
Enters "No" in response to Yes/No queries.
In a sign (polarity) field, selects the negative (-) sign.
In a name field, changes UPPER CASE letters to lower case.
3.1 C
D URSOR
When editing, this key positions the cursor (a single underline character, showing that a
parameter is ready for editing) under the next field to the left. (Note: It will not move across
page boundaries.)
3.1 C
E URSOR
When editing, this key positions the cursor (a single underline character) under the next field
to the right. (Note: It will not move across page boundaries.)
A M20 R
LESIS EFERENCE
M20 O
9
BUTTONS
/Y /U
RROW ES PPER
A /N /L
RROW O
L
EFT
R
IGHT
M 1.06
ANUAL
P
ARAMETERS
C
ASE
C
OWER ASE
CHAPTER 3
PERATING
3-1