Connecting Power And A Sub1/Sub2; Autooff/Low-Power Standby - Bose L1 Pro32 Owner's Manual

Setup
PRO.BOSE.COM

Connecting Power and a Sub1/Sub2

r t
q w e
Sub1/Sub2 L1 Pro32
1. Plug the SubMatch cable into the SubMatch Input on a Sub1/Sub2.
2. Plug the other end of the SubMatch cable into the SubMatch Output of the L1 Pro32.
3. Plug the power cord into the Power Input on the L1 Pro32.
4. Plug the other end of the power cord into a live electrical outlet.
Note: Do not power on the L1 Pro until after you've connected your sources. See Connecting Sources on
page 9.
5. Press the Standby Button. The LED will illuminate white while the L1 Pro is on.
Note: Press and hold the Standby Button for 10 seconds to reset the L1 Pro to factory settings.
Press the Standby Button on any connected Sub1/Sub2. For additional information on how to set up a Sub1/
Sub2, see the Sub1/Sub2 owner's guide at PRO.BOSE.COM.
Note: When two Subs are connected to the L1 Pro32, first turn on the Sub connected directly to the L1 Pro32,
then turn on the second Sub.

AutoOff/Low-power Standby

After four hours of no use, the L1 Pro will enter AutoOff/Low-power Standby mode to save power. To wake
the L1 Pro from AutoOff/Low-power Standby mode, press the Standby Button. When the L1 Pro32 goes into
AutoOff/Low-power Standby mode, this will cut power to any Sub1/Sub2 connected with a SubMatch cable.
Press the Standby Button on a connected Sub1/Sub2 to wake it from AutoOff/Low-power Standby mode.
Note: Disable AutoOff/Low-power Standby mode by pressing and holding all three Channel Parameter
Controls for 10 seconds, or via the Settings page in the L1 Mix app. Enable AutoOff/Low-power Standby mode
by repeating this step. Disabling AutoOff/Low-power Standby mode will result in higher energy usage when
the L1 Pro is not in use.
8 • English L1 Pro32 Portable Line Array • Owner's Guide