Programmed Play - Aiwa XR-X7 Operating Instructions Manual

Random/Repeat play
In random play mode the unit plays all the tracks in random
order. In repeat play mode it plays repeatedly all the tracks or
the track being played. You can select random and repeat all
play at the same time.
1 Hold down SHIFT and press RANDOM/REPEAT
repeatedly to select one of the following modes:
" " 1": Repeat 1 play
" " ": Repeat all play
"RANDOM": Random play
"RANDOM " ": Random/Repeat all play
2 Press c to start play.
To cancel random/repeat play
Hold down SHIFT and press RANDOM/REPEAT repeatedly
until "RANDOM", " " 1" or " " " disappears.
Direct selection of the tracks with the numbered buttons
cancels random play mode.
To repeat a selected set of tracks
First select the tracks with programmed play (see
"Programmed play" on this page).
Then select repeat playback.

Programmed play

Plays back up to 30 selected tracks in programmed order.
1 Hold down SHIFT and press PROGRAM on the
remote control in stop mode.
"PRGM" flashes on the display.
2 Press the numbered buttons on the remote
control to program a track.
-To select the 25th track, press +10, +10 and 5.
-To select the 10th track, press +10 and 0.
The selected track number lights up on the display.
3 Repeat step 2 to program other tracks.
The total number of selected tracks and total playing time
will be displayed.
4 Press c to start play.
The track number for the current track flashes on the
display.
•During programmed play, you cannot select a track with the
numbered buttons. "Can't USE" is displayed when you
try to select a track .
•If the total playing time of the program exceeds 99 minutes
and 59 seconds, or if a track with a track number exceeding
30 is programmed, the playing time is displayed as
"- - - -:- - - -".
•You cannot program more than 30 tracks. "FULL" is
displayed.
To check the program
Press f or g repeatedly in stop mode. The track
number and program number are displayed in succession.
To clear the program
Press s in stop mode. "PRGM" disappears from the display.
To add tracks to the program
Repeat step 2 before starting play. The tracks are added to the
end of the program.
To change the programmed tracks
Clear the program and repeat all the steps again.
Notes on CDs
•Do not place more than one disc.
•Do not tilt the unit with a disc loaded.
•The unit may not play CD-R/RW discs recorded on personal
computers or certain kinds of CD-R/RW recorders.
•Do not attach adhesive label to either side of CD-R/RW discs,
as doing so may cause malfunction.
•Do not load an unrecorded CD-R/RW disc. The disc may be
damaged.
•Do not touch the CD pickup lens. If it is soiled, CDs may
not be played normally.
En
11