Advertisement
p
x
n
f
n
p
x
v
q
q
16
l
m
CLICK!
x
f
n
e
f
d
w
SECURING THE CHILD WITH THE IMPACT SHIELD – UN
GROUP 1 (9-18 KG)
1. Now insert the previously adjusted impact shield (p) (refer to the section
"ADJUSTING THE IMPACT SHIELD").
2. Pull out the entire length of the vehicle's three-point belt. Take the lap belt (n) and
place it in the designated belt guide (x) in the impact shield (p).
WARNING! Never twist the belt!
WARNING! The three-point belt may only be inserted into the guides
designated for that purpose. The belt guides are described precisely in this
manual and are also marked red on the child car seat.
3. Insert the belt tongue (m) into the belt buckle (l). It must lock into place with an
audible "CLICK".
4. Tighten the lap belt (n) by pulling the diagonal belt (f).
5. Now feed the diagonal belt (f) in parallel with the lap belt (n) back into the belt
guide (x).
6. Pull the diagonal belt (f) tight and ensure that both parts of the belt cover the entire
width of the impact shield (p) in the belt guide (x).
7. Now feed the diagonal belt (f) tightly through the belt guide (x) of the impact shield (p)
until it is clamped inside the belt guide. Then put the diagonal belt between headrest
(e) and shoulder rest. The diagonal belt does not need to be guided through the
headrest belt guide for group 2/3.
SWITCHING FROM PALLAS M TO SOLUTION M (UN GROUP 1
TO UN GROUP 2/3)
1. Remove the impact shield (p).
2. Press the two release buttons (q) on the underside of the seat cushion (d) and pull
it away from the frame until there is some resistance.
3. Press the adjustment button (v) and pull the seat away from the frame (w)
completely.
Note! Keep removed parts together in a safe and secure place.
WARNING! When reassembling the seat, proceed in precisely the reverse
order. Use the instructions to check beforehand if all parts are present.
Advertisement
Chapters
