Radio Operation - Aiwa CT-FX531M Operating Instructions Manual

Adjusting sound
You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/rear), H-BASS (high bass)*, and DSSA
(Drivers Sound Stage Adjustment)**
* You can reinforce the bass sound.
** You can adjust sound stage and tone balance to best
serve a particular seat in the car.
1
Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode's indicator appears.
2
Turn the Smart Jog to increase or decrease the level
for the selected mode (except for H-BASS and
DSSA).
In H-BASS mode, turn the Smart Jog to select 1
(low), 2 (medium), 3 (high), or OFF.
In DSSA mode, turn the Smart Jog to select L (for the
front left seat), R (for the front right seat), or OFF.
Notes
• Adjust the level or select an item within 5 seconds, or
the selected mode will return to previous state.
• When DSSA is activated, you cannot adjust BAL, FAD,
BASS, and TRE.
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode's
volume to almost the same level.
1
Press FNC repeatedly to select the desired mode.
2
Press DISP while pressing SEL.
"LEVEL 0" appears in the display.
3
Turn the Smart Jog to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
3 3
ENGLISH ENGLISH
Restoring the factory settings
1
Turn off the unit.
2
Press and hold DISP until "LEVEL --" appears in the
display.
Note
You can restore the factory settings only for VOL, BASS,
TRE, BAL, FAD, H-BASS, and DSSA and aligned
source volume levels.
Muting button beep sounds
1
Turn off the unit.
2
Press and hold SEL until "BEEP" appears in the
display.
3
Turn the Smart Jog to select ON or OFF.
4
Press SEL.
The unit turns off.
Setting the clock
1
Press and hold SEL until the clock indication flashes
in the display.
2
Press TUNEi (to set hour) or TUNEk (to set
minute) and turn the Smart Jog.
3
Press SEL.
Displaying the clock
1
Press DISP.
To return to the former display, press DISP again.

RADIO OPERATION

Tuning in to a station
(Seek/Manual Tuning)
Band indicator* Frequency
indication
* "F" means FM, and "A" means AM.
Stereo indicator
Local indicator