Chevrolet Equinox 2021 Owner's Manual page 35

34 Seats and Restraints
To begin Seat Exit Memory movement
when the vehicle is turned off and the
driver door is opened, or when the vehicle
is turned off with the driver door already
opened, select the Settings menu, then
Vehicle, then Seating Position, and then
Seat Exit Memory. Select On or Off. See
Seat Exit Memory later in this section.
See Vehicle Personalization 0 107 for
additional setting information.
Identifying Driver Number
To identify the driver number:
1. Move your RKE transmitter away from
the vehicle.
2. Start the vehicle with another key or RKE
transmitter. The DIC should display the
driver number for the other RKE
transmitter. Turn the vehicle off and
remove the key or RKE transmitter from
the vehicle.
3. Start the vehicle with the initial key or
RKE transmitter. The DIC should display
the driver number of your RKE
transmitter.
Saving Memory Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions 1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY.
A DIC welcome message may indicate
driver number 1 or 2.
2. Adjust all available memory features to
the desired driving position.
3. Press and release SET; a beep will sound.
4. Immediately press and hold the 1 or
2 memory button matching the above
DIC welcome message until two beeps
sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be saved and
two beeps will not sound. Repeat
Steps 3 and 4.
1 or 2 corresponds to the driver number.
See Identifying Driver Number
previously in this section.
5. Repeat Steps 1 4 for a second driver
using 1 or 2.
To save the position for and Seat Exit
Memory features, repeat Steps 1 4 using
. This saves the position for getting out
of the vehicle.
Save preferred memory feature positions to
both 1 and 2 if you are the only driver.
Manually Recalling Memory Positions
Press and hold 1, 2, or to recall the
previously saved memory positions if you
are driver 1 or 2 identified in the DIC
welcome message. RKE transmitters 3 8 will
not recall memory positions.
To stop Manual Memory recall movement,
release 1, 2, or or press any of the
following controls:
Power seat
Memory SET
Power mirror, with the driver or
passenger side mirror selected
Manual Memory recall movement for 1, 2,
or buttons may be initiated and may
complete to the saved memory position if
the vehicle is in or out of P (Park).
Seat Entry Memory
The vehicle identifies the number of the
current driver s RKE transmitter (1 8). See
Remote Keyless Entry (RKE) System
Operation 0 7. If the RKE transmitter is 1 or
2, and Seat Entry Memory is enabled in
vehicle personalization, the positions saved
to the same memory button number 1 or 2