Chevrolet Equinox 2021 Owner's Manual page 217

216 Driving and Operating
: Press to turn the system on or off. The
indicator turns white on the instrument
cluster when ACC is turned on.
RES+ : Press briefly to resume the previous
set speed or to increase vehicle speed if ACC
is already activated. To increase speed by
about 1 km/h (1 mph), press RES+ briefly. To
increase speed to the next 5 km/h (5 mph)
mark on the speedometer, hold RES+.
SET : Press briefly to set the speed and
activate ACC or to decrease vehicle speed if
ACC is already activated. To decrease speed
by about 1 km/h (1 mph), press SET briefly.
To decrease speed to the next 5 km/h
(5 mph) mark on the speedometer,
hold SET .
: Press to disengage ACC without erasing
the selected set speed.
: Press to select a following gap setting
for ACC of Far, Medium, or Near.
The speedometer reading can be displayed
in either English or metric units. See
Instrument Cluster (Base and Midlevel) 0 84
or
Instrument Cluster (Uplevel) 0 87. The
increment value used depends on the units
displayed.
Switching Between ACC and Regular Cruise
Control
To switch between ACC and regular cruise
control, press and hold . A Driver
Information Display (DIC) message displays.
See Vehicle Messages 0 106.
ACC Indicator Regular Cruise Control
Indicator
When ACC is engaged, a green
will be lit on the instrument cluster and the
following gap will be displayed. When the
regular cruise control is engaged, a green
indicator will be lit on the instrument
cluster; the following gap will not display.
When the vehicle is turned on, the cruise
control mode will be set to the last mode
used before the vehicle was turned off.
Always check the cruise control indicator
on the instrument cluster to determine
which mode cruise control is in before
using the feature. If ACC is not active, the
vehicle will not automatically brake for
other vehicles, which could cause a crash
if the brakes are not applied manually.
You and others could be seriously injured
or killed.
Setting Adaptive Cruise Control
If is on when not in use, SET /RES+
could be pressed by mistake and engage
indicator
ACC when not desired. Keep
cruise is not being used.
Select the set speed desired for ACC. This is
the vehicle speed when no vehicle is
detected in your path.
While the vehicle is moving, ACC will not set
at a speed less than 5 km/h (3 mph),
although the minimum allowable set speed
is 15 mph.
To set ACC while moving:
1. Press .
2. Get up to the desired speed.
Warning
off when