Advertisement
Step 6
Make sure POWER, WAN, WLAN, and the LAN port that the
computer is connected to are lit. If not, try the above steps again.
LED Indicators:
Light
LED
Description
Status
POWER
On
Router is powered on.
On
WPS setup is in progress.
WLAN
Off
Wireless network is switched off.
Wireless network is ready and WPS setup is
Flashing
not in progress.
On
WAN port is connected.
WAN
Off
WAN port is not connected.
LNK/ACT
Flashing
WAN port is transferring or receiving data.
On
LAN port is connected.
LAN 1-4
Off
LAN port is not connected.
LNK/ACT
Flashing
LAN port is transferring or receiving data.
Step 7
Enter the Router's password to log in to the Router. The default
password is "admin". It is recommended to change the router's password to
protect it from being accessed by other users. If you do not wish to change
the current password, you can leave New Password and Confirm New
Password blank. Click Next.
Step 8
Verify the Internet Connection Type the wizard detected. If it is not
correct, please configure it manually. Click Next.
Note: If you are not sure which Internet Connection Type you use, please
contact your Internet Service Provider for this information.
Advertisement
