Setting The Network Configuration - Avaya J169 Manual

Getting Started
8. If the security is 802.1x EAP, enter the following:
• Identity: Either your personal user ID or the shared user ID provided by your system
administrator.
• Anonymous Identity: Leave blank or use the shared Anonymous Identity provided by
your system administrator.
• Password: Either your personal password or the shared password provided by your
system administrator.
Result
If the credentials are authenticated successfully, the phone automatically restarts to complete the
connection.
Related links
Setting the network mode

Setting the network configuration

About this task
To set the network configuration to Auto or Manual. You do not need to perform this procedure if
your phone is configured to connect to Ethernet or a specific Wi-Fi network.
When network configuration is Auto, every time the phone restarts, it will connect to the pre-
configured network that your administrator has set up.
When network configuration is Manual, every time the phone restarts, it will connect to the network
that you manually configured by
network on page 25, irrespective of the pre-configured network that your administrator has set up.
Note:
Any time you manually change the connected network, the phone will automatically set
Network config to Manual.
Procedure
1. Press the Main menu.
2. Scroll to Settings and press Select.
3. Scroll to Network and press Select.
4. Scroll to Network config.
The Network configuration shows following two options:
• Auto: To automatically connect a network.
• Manual: To manually connect to a network.
5. Press one of the following:
• Toggle
April 2021
on page 24
Setting the network mode
Using Avaya J169 and J179 SIP IP Phones in Open SIP
Comments on this document? infodev@avaya.com
on page 24 or Connecting to a Wi-Fi
26