Setting The Network Configuration - Avaya J129 User Manual

6. When Network mode displays Wi-Fi, the following lines are shown on the Phone screen:
• SSID: The name of the Wi-Fi network that the phone is either currently connected to, or
will attempt to connect to if you start the connection process.
• Wi-Fi network: Scroll to this line and press Select to view the list of Wi-Fi networks.
7. After selecting the network mode, press Save.
8. When you switch Network mode from Ethernet to Wi-Fi, see "Connecting to a Wi-Fi
network" section.
9. When you switch Network mode from Wi-Fi to Ethernet , press Save.
10. When the phone prompts for permission to restart, press OK.
Press Cancel to go back to previous step.
Related links

Setting the network configuration

Connecting to a Wi-Fi network
Setting the network configuration
About this task
To set the network configuration to Auto or Manual. You do not need to perform this procedure if
your phone is configured to connect to Ethernet or a specific Wi-Fi network.
When network configuration is Auto, every time the phone restarts, it will connect to the pre-
configured network that your administrator has set up.
When network configuration is Manual, every time the phone restarts, it will connect to the network
that you manually configured by
network on page 52, irrespective of the pre-configured network that your administrator has set
up.
Note:
Any time you manually change the connected network, the phone will automatically set
Network config to Manual.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll to Network, and press Select.
4. Scroll to Network config.
The Network configuration shows following two options:
• Auto: To automatically connect a network.
• Manual: To manually connect to a network.
October 2019
on page 51
on page 52
Setting the network mode
Using Avaya J129 IP Phone in an Open SIP environment
Comments on this document? infodev@avaya.com
Setting the network mode
on page 50 or Connecting to a Wi-Fi
51