Your Thread Stand - Encore sitdown User Manual

Your Thread Stand

Your Encore 18x6 Sitdown model comes
with a four-spool Thread Stand.
assembly required.
Attach the upper thread support to the cone
support base.
1. Place the upper thread support into the
hole provided on the base between the
cone holders.
2. Use the screw provided to secure the
upper thread support into place.
To attach the Thread Stand on the side of
the machine with the motor, you will see two
screws toward the front of the machine.
1. Loosen the two screws on the side of the
machine.
2. Slide the Thread Stand over the two
screws.
3. Level the Thread Stand with the top of
the machine.
4. Tighten the two screws to hold the
Thread Stand securely in place.
6 | Encore 18x6 Sitdown Model User Guide
Some