Toshiba B-EP Series Interface Specification page 98

TPCL mode (Storing writable characters, PC save)
Request for a Bluetooth
connection
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior
to a data transmission.)
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
Bit map writable character
command or Save
command
- [ESC]XD . . . [LF][NUL]
- [ESC]XO . . . [LF][NUL]
to [ESC]XP[LF][NUL]
Request for a disconnection
of the Bluetooth connection
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Host Printer
start
Min. 100msec.
3-67
Response to the request for a Bluetooth
connection
Status sent in response to the status
request command.
SOH STX Status Unprinted count ETX EOT CR LF
01H 02H 30H30HxxH 3xH3xH3xH3xH 03H 04H 0DH 0AH
Make sure that the printer is in
idle state.
Provide 100 msec. or more wait
time after the termination of data
transmission via Bluetooth.
Response to the request for the disconnection
of the Bluetooth connection
CHAPTER 3 INTERFACE
B-EP Series
Confirmation
of the printer
status prior
to data
storage
Data
storage