Transaction Processing Options - Ingenico MOVE/5000 User Manual

Transaction processing options

Your EFTPOS terminal has a chip card reader, a magnetic stripe reader and an integrated
contactless reader for processing transactions.
Chip Card Reader
All chip cards must be inserted into the chip card reader located in front of the terminal
below the keyboard.
• Insert the credit card into the card reader with the gold contact pad facing upward.
• Leave the chip card in the reader until the transaction is completed.
• Remove the card when prompted by the terminal.
• The terminal screen prompts will guide you through the transaction process.
Contactless Reader
The contactless reader is located on top of the receipt roll around the display.
• If the card is capable of performing a contactless transaction, place the card over
the contactless reader.
• When the terminal is powered on, the first LED will blink on and off while the
terminal is in Idle/Ready state.
• All 4 status LEDs will be illuminated from the time the card reader is activated until
completion of the contactless transaction.
Magnetic Stripe Reader
The magnetic stripe card reader is located on the right hand side of the terminal.
If the card does not have a chip or contactless capability, you can process transactions
by swiping the magnetic stripe through the terminal. The magnetic stripe should face
down and against the side of the terminal.
10 Ingenico MOVE/5000 Terminal User Guide