Multiconference Setup - Aethra Vega X5 User Manual

Multiconference Setup

Before activating a multiconference session, configuration is required.
H P
From the
OME AGE
S / M
ETTINGS ULTICONFERENCE
The following will be displayed:
In this menu you can set:
Network Type:
Conference Type
(example: for an MCU IP you select 7@128 from the drop-down menu, which means that the
MCU will allow the System to manage a multiconference with a maximum of 7 terminals
(including itself), via IP, with a maximum rate of 128K for each connection).
Preferred
Audio Coding
Preferred
Video Coding
Go to the corresponding drop-down menu, press
keys on the remote control make your selection and press
<Auto> is the default setting.
In addition, you can select the following options:
Dual Video H.239
G.722.1
H.264
Auto adjust rates
If automatic adaptation is enabled, the System will automatically adapt the multiconference to
the audio/video encoding and bit rate of the lowest quality connection within the conference,
without excluding any participant.
Tx Continuous Presence
Enable/Disable transmission of Continuous presence: for multiconferences (at least two
participants) all participating sites receive the signals simultaneously from all participating
terminals.
Ask to save scenario
At the close of the multiconference, the system asks whether save in the phonebook all
information needed to repeat it, with an editable "conference name".
select:
, or
IP ISDN Mixed
: allows you to select the number of participants and the desired rate
and
Auto adjust coding
.
OK
, with the aid of the arrow
OK
again to confirm.
81