Table of Contents
Advertisement
Control panel
In these pages you can configure some system parameters.
General
Screensaver
Remote control
General
Show Local Info
If activated, shows information such as terminal name, ISDN number, and IP address on the
monitor in graphical form.
Show warnings
If activated, allows visualization of "Bonding Recovery" messages.
Show logo when in a call
Enables/disables logo display during a call. Logo is customizable—default is Aethra S.p.A.
Disable still picture
disable transmission/receiving of "still images".
Send received still to TFTP server
Disable or enable and configure TFTP server (to obtain server
your network administrator). If enabled, still images can be sent and stored in a TFTP (Trivial
File Transfer Protocol) server. These still images will be available for future use.
Enable startup jingle
If activated, allow the jingle to every reboot of the system.
Show video name
If activated, allows visualization of the remote terminal "Name".
Screensaver
Automatic screensaver
to enable/disable the automatic screensaver function, and to set its timeout.
XGA on screensaver
Enable/disable XGA loop function: "XGA IN" signal sent to "XGA OUT."
Two possible cases:
•
Active "XGA IN" signal: monitor shows XGA signal.
•
Inactive "XGA IN" signal: no signals on monitor ("Stand By" mode).
38
.
:
:
:
:
:
:
, please contact
IP address
Advertisement
Table of Contents
