Table of Contents
Advertisement
Safety Rules For Batteries
• Risk of explosion if batteries are replaced by
an incorrect battery type. Dispose of used
batteries following the user instructions.
• The batteries of this equipment must be
disposed of by either a recycling company or a
company qualified for the disposal of dangerous
materials. The battery may also be disposed of in
special recycling containers specifically for worn
out battery (this may vary form country to
country).
• Only use the same type of battery that was
originally provided with the equipment.
• Replace the batteries when the remaining
power charge significantly low. Do not recharge.
• Do not use any damaged batteries.
• Do not to use the batteries for different
reasons from those prescribed.
• Do not short circuit the batteries (direct
contact between + and – poles of the battery).
This can happen accidentally during the
maintenance of the equipment or the replacement
of the worn out batteries.
• Do not put the batteries close to flames,
sparks, radiators, microwave ovens, fireplaces,
direct sun light or other sources of heat. Do not
throw the batteries into the fire.
• Do not weld directly on the battery terminals.
• Do not install the batteries with the polarity
upside down. Please refer to the installation
instructions for battery installation.
• Do not damage the batteries in any way. Do
not try to open or to pierce the batteries.
• Avoid any accidental collision as it could
cause the batteries to rupture and leak corrosive
liquids or irritable vapours. In such case
disconnect the power immediately from the
equipment and batteries.
• In case the battery liquids comes into contact
with your skin or garments, wash the area
immediately with water. If it comes into contact
with your eyes, wash immediately with plenty of
water and contact either a doctor or the nearest
first aid office immediately.
• Keep away from the children's reach.
Cleaning
To clean the device use a dry soft cloth (or with a
little bit of gentle detergent). Never use solvents,
such as alcohol or gasoline, to avoid damaging the
finish.
8
Warnings
Many of the components used in this device are
sensitive to electrostatic charge.
When handling the connection cables, disconnect
the power supply and avoid direct contact with the
connector terminals.
When handling electronic components, touch a
grounded surface to eliminate any static electricity.
If possible, wear a grounding arm band.
Failure to comply with these warnings could cause
permanent damage to this device.
EN 55022 Class A Compliance
This is a Class A product. In a residential
environment this product may cause radio
interference. In such case the user may need to
take adequate measures.
FCC 15 Class A Compliance
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions manual, may
cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
CE Mark
Aethra S.p.A. hereby declares that this device
complies with essential requirements and other
relevant notes of R&TTE Directive 1999/5/EC.
The declaration of conformity maybe obtained
from:
Aethra S.p.A.
Via Matteo Ricci, 10 - 60126 Ancona – Italy
www.aethra.com - aethra@aethra.com
Advertisement
Table of Contents
