Viessmann VIESMANN VITOLIGNO 300-H Technical Manual page 47

Fuel storage
(cont.)
Window installation with screws
A plate is set into the window opening. The connector is fitted through
the plate, secured with screws and earthed with a pipe clip.
B A
A Fill connector
B Screws
C Pipe clip for earthing
D Outlet Ø 110 mm (on-site) for fill connector A
E Window opening
Accessories for the on-site pellet store
Deflector 1.0 x 1.2 m
Part no. 7267 128
The deflector comprises a 4.0 mm thick pressed rubber mat with fibre-
reinforcement for high strength.
Install deflector B at least 100 mm from the wall opposite the fill con-
nector. This deflector protects the pellets, the brickwork and the plas-
ter/render.
Pieces of plaster/render or wall that have been prised off can hinder
the pellet supply and ash removal from the boiler.
Standard delivery
■ Deflector 1.0 x 1.2 m
■ Section anchor with carbine fastening
A
C
A Fill connector
B Deflector (1000 x 1200 mm)
C Fill width approx. 4 - 5 m
VITOLIGNO 300-H
C
D
E
B
≥200 mm
Installation in the light well
Wall installation and installation in the window opening are both pos-
sible. The trimmed delivery and return air connectors are each pushed
into a 45° bend, which in turn is located in an extension pipe pushed
through the wall or the window opening.
B
A
E
A Fill connector
B Pipe clip for earthing
C Extension pipe
D Wall outlet Ø 110 mm (on-site)
or
Outlet Ø 110 mm (on-site)
E 45° bend
Pellet filling system, straight
Part no. 7527 539
■ With flared flange on both sides
■ 2 fill connectors
■ 2 Storz A couplings with clamping ring
■ Without lid (must be ordered separately)
DN100
Pellet filling system 45° for pellet silo
Part no. 7527 540
For type 29, 17/29 and 21/29 (see Vitoset pricelist)
■ With flared flange on both sides
■ 2 fill connectors
■ 2 pipe bends, 45°
■ 2 Storz A couplings with clamping ring
■ Without lid (must be ordered separately)
C
D
6
VIESMANN
47