Advertisement
Installation, Maintenance & Troubleshooting guide | Version 04
4) LMR-A: Auto mode
a. WLCA- Delivery mode
12A
: Check the mode of LMR-A, if it is Auto mode.
12B
: Check the mode of WLC-A, if it is Delivery mode.
12C to 12J
: Follow steps from 12C to 12J of Manual & Delivery mode. Refer Table 22 (Corrective action 1)
12K
: No need to press ON push button.
12L
: Starter switches ON automatically.
12M to 12N : Follow steps from 12M to 12N of Manual & Delivery mode. (Corrective action 1)
5) LMR-A: Auto mode
b. WLCA- Suction mode
12A
: Check the mode of LMR-A, if it is Auto mode.
12B
: Check the mode of WLC-A, if it is Suction mode.
12C to 12J
: Follow steps from 12C to 12J of Manual & Delivery mode. Table 22 (Corrective action 1)
12K
: No need to press ON push button.
12L
: Starter switches ON automatically.
12M to 12N : Follow steps from 12M to 12N of Manual & suction mode. (Corrective action 2)
6) LMR-A: Auto mode
c. WLCA- Dual tank mode
12A
: Check the mode of LMR-A, if it is Auto mode.
12B
: Check the mode of WLC-A, if it is Dual Tank mode.
12C to 12J
: Follow steps from 12C to 12J of Manual & Delivery Tank mode. Table 22 (Corrective action 1)
12K
: No need to press ON push button.
12L
: Starter switches ON automatically.
12M to 12N : Follow steps from 12M to 12N of Manual & dual tank mode. (Corrective action 3)
β LMR-A: Bypass mode
c. WLCA- In any 3x mode (Delivery, Suction, Dual Tank)
As in Bypass mode there is no protection from the incoming supply faults, however there may be some conditions,
example mentioned below where Starter may not ON –
4. Phase loss
5. Incoming supply voltage less than the minimum required operational voltage of the Starter.
6. Incoming supply voltage is very high etc.......
Also check the WLC-A faults which may arise due to the sensor misplacement in the tank. Refer
In the above conditions check the Starters as explained in Auto & Manual Mode.
21
Note.
6
Advertisement
