Advertisement
Installation, Maintenance & Troubleshooting guide | Version 04
LMR-A: Bypass mode
a. WLCA- Delivery mode
10A : Keep the LMR-A in Bypass mode.
10B : Keep the WLC-A in Delivery mode.
10C : Switch ON the 3-Phase incoming main supply.
(*Customer may switch ON the starter directly after switching ON the 3 phase incoming supply
irresepctive of Blinking status as there is only indication for incoming supply faults and no Protection
in Bypass mode).
10D : Turn ON the rocker switch.
10E : Amber LED will start blinking for a period of min 0.5 min.
10F : 0.5 min is the default setting which can vary from min 0.5 min to max.5min.
10G : After the ON-delay duration, amber LED will ON continously indicating that the incoming supply is
healthy(Assuming incoming supply is healthy). WLC-A R LED will turn ON when P2,P3 sensors of
WLC-A are out of water.
10H : Press the green push putton for switching ON the starter.
10I : Starter gets switched ON.
10J : Green LED turns ON indicating that the starter is ON.
10K : Delivery tank gets filled till the water touches the level of P3 sensor.
10L : Starter switches OFF automatically after delivery tank water level reach P3 sensor level.
10M : Green LED turns OFF indicating that the starter is OFF.
10N : Amber LED indication remains continous ON.
10O : Switch OFF the 3-phase incoming main supply.
10P : Amber LED indication gets turned OFF indicating that there is no incoming main supply.
LMR-A: Bypass mode
b. WLCA- Suction mode
10A : Keep the LMR-A in Manual mode.
10B : Keep the WLC-A in suction mode.
10C : Switch ON 3-Phase incoming main supply.
(*Customer may switch ON the starter directly after switching ON the 3 phase incoming supply
irresepctive of Blinking status as there is only indication for incoming supply faults and no Protection
in Byapass mode).
10D : Turn ON the rocker switch
10E : Amber LED will start blinking for a period of min 0.5 min.
10F : 0.5 min is the default setting which can vary from min 0.5 min to max.5min.
10G : After the ON-delay duration, amber LED will ON continously indicating that the incoming supply is
Healthy (Assuming incoming supply is healthy). WLC-A R LED will turn ON when P1,P2,P3 sensors are in water.
10H : Press the green push putton for switching ON the starter.
10I : Starter gets switched ON
10J : Green LED turns ON indicating that the starter is ON.
10K : Water gets drawn out of the suction tank till the water level goes below P2 sensor.
10L : Starter switches OFF automatically after Water level of the suction tank goes below P2 sensor.
10M : Green LED turns OFF indicating that the starter is OFF.
10N : Amber LED indication remains continous ON.
10O : Switch OFF the 3-phase incoming main supply.
10P : Amber LED indication gets turned OFF indicating that there is no incoming main supply.
16
Advertisement
