Rinnai Linear 1000 Installation Instructions Manual

Linear 1000
Burn media installation
Experience has shown that the majority of performance problems are caused by burn media being
installed incorrectly. Please take the time to read and follow these instructions as malfunctioning
due to incorrect burn media placement is not covered by warranty.
• The Linear MUST NEVER be used with other burn media or burn media that is damaged.
• The Linear burn media sets are different and cannot be interchanged, ensure you have ordered
the correct set before installation.
Correct placement
It is important to place the burn media in the correct position. Incorrect placement can create
carbon build-up and affect performance.
Single-sided/double-sided
When installing the burn media you will ALWAYS be working on the side where the pilot assembly
is, to the back of the firebox.
R2902 Linear driftwood log set kit contents
Part number Description
13044 Vermiculite
13476 Wire wool (glowing ash)
13480 Log set A and stone set
13482 Log set C
Log set A and stone set come packaged in the same box
1
R2904 Linear 1000 crushed glass kit contents
Part number Description
13473 Crushed black glass
13476 Wire wool (glowing ash)
Quantity
1 bag (approx. 0.75 L)
1 bag (approx. 3 g)
4 logs and 9 stones
1
1 log
Quantity
3 bags (approx. 2.5 kg)
1 bag (approx. 3 g)
Important
Ensure the gaps between the
burners are kept clear of any
vermiculite or crushed glass.
This is important as these gaps
provide secondary air to the
unit.
A tip to stop any burn media
going into the gaps is to place
the installation guide in the
burner gap while placing the
vermiculite or crushed glass
over the burner.
Linear 1000 burn media installation: 13569-C | 1