Mitsubishi 900 Series User Manual page 57

2) An internal diagram of the control panel is shown below.
Connector which can
ground earth line to
casing of connector
*1: Separately ground the power wire and signal wire.
*2: Power wire and the signal wire must separated by a separate shield and ground to FG.
3) Notes when cable is made.
• The cable must be 200m or shorter.
• When branching inside and outside the control panel, use a connector in between.
The connector used must be able to attach the earthing to the connector casing.
• When the cable is made, the terminal 24VDC of the connector on the GOT side is connected
with the 24VDC power supply of the control board.
Therefore, it should not be connected to the power supply terminal in the back of the main body
of GOT.
6 - 12
6.1 GOT Main Unit
6.1.4 Installation of handy type GOT
Inside control panel
Ground wires
(Ground to the connector's metal section.)
*1
24VDC wire
FG wire
Computer link module
*2
FG wire
12/24VDCpower