Download Print this page

Plumbing Installation - Kohler EVOK 22160A-0 Installation Instructions Manual

Freestanding back-to-wall bath

Advertisement

B. Plumbing Installation
1) To connect the plumbing raise the freestanding bath off the floor by propping it up onto timber blocks
positioned at either end of the bath. The Evok BTW Freestanding Bath is supplied with a pop-up waste
system which has a DN40 outlet with BSP 1 1/2'' thread. Connect the waste to an appropriate trap.
2) After plumbing is complete and before lowering the bath check for leaks. Kohler NZ shall not be liable
under its warranty for damage caused by negligence.
3) Carefully lower the bath back onto the floor.
Note: Take care while maneuvering the bath not to damage the base of the of the bath and subfloor.
C. Securing the bath in position
Carefully shift the bath so that the bath feet slide into the mounting clips.
Note: Once the bath is in place, check that it is secure. If there is a loose
connection between the clips and bath feet, remove the bath and adjust the
nuts on the bath feet as necessary.
Apply a thin continuous bead of clear or color-matched silicone sealant
between the base of the bath and the finished floor. Leave the bath
for a minimum of 24 hours to allow the silicone to cure.
CAUTION: Risk of property damage
• Ensure a watertight seal on the bath drain and plumbing.
• Install the faucet valve according to the faucet manufactuer's instructions.
• Do not install the faucet trim until instructed.
• Turn on the hot and cold water supplies and check connections for leaks.
CLEANING AND CARE
• Use a mild detergent such as liquid dishwashing soap and warm water to clean the bath. Do not use
abrasive cleaners that may scratch or dull the surface.
• Take care to read the label of cleaning products to ensure the cleaner is safe for use with acrylic material.
• Before using an intended cleaning product, test the cleaning solution on an inconspicuous surface.
• Do not allow cleaners to sit or soak into the surface of the bath.
• Wipe surfaces clean and rinse completely with water immediately after cleaner is applied.
• Use a soft dampened cloth or sponge. Never use an abrasive material such as a scouring pad to clean
bath surfaces.
INSTALLATION COMPLETE
5

Advertisement

loading

This manual is also suitable for:

Evok 22161a-0