Honda GOLDWING GL1800/A 2015 Owner's Manual page 190

Changing Oil
Refer to Safety Precautions on
RIGHT REAR
Change the oil with the final drive at normal operating temperature to assure
complete and rapid draining.
1. Place the motorcycle on its center stand on a firm, level surface.
2. Place a drain pan under the drain bolt.
3. Remove the oil fill cap, drain bolt and sealing washer.
4. After the oil has completely drained, check that the sealing washer is in good
condition. Reinstall the drain bolt with its sealing washer (or a new washer, if
necessary) and tighten it to the specified torque:
15 lbf·ft (20 N·m , 2.0 kgf·m)
5. Pour the drained oil into a suitable container and dispose of it in an approved
manner (page 223).
Improper disposal of drained fluids is harmful to the environment.
6. Fill the final drive with the recommended oil:
4.1 US oz (120 cm
Make sure the final drive oil level is at the lower edge of the oil fill inspection
hole.
7. Install the oil fill cap.
page
sealing washer
)
3
Final Drive Oil
154.
oil fill cap
drain bolt
Servicing Your Honda
lower edge
187