• Specifications can be found on the product page at https://www.tp-link.com. • A TP-Link Community is provided for you to discuss our products at https://community.tp-link.com. • Our Technical Support contact information can be found at the...
Chapter Get to Know About Your Adapter This chapter introduces what the adapter can do and shows its appearance. This chapter contains the following sections: • Product Overview • LED Status...
Get to Know about Your Adapter 1. 1. Product Overview Combined with the latest 10GBase-T Technology, TX401 delivers extreme speeds of up to 10 Gbps, which is 10× faster than typical Gigabit adapters, guaranteeing smooth data transmissions for all your bandwidth-intensive tasks.
Chapter Connect to a Computer This chapter introduces how to connect the adapter to your computer.
Page 7
Chapter 2 Connect to a Computer Before you begin using your adapter, insert the adapter into your computer by following these steps. 1. Turn off the computer, unplug the power cable and remove the case panel. 2. Locate an available PCI-E slot and carefully insert the adapter. Note: If the bracket is not suitable for your computer, detach it from the adapter’s board and replace it with the low-profile bracket provided.
Chapter Install Driver This chapter introduces how to install your adapter’s driver in different Windows systems, including Windows 7/8/8.1/10.
Page 9
1. Insert the CD and run the Autorun.exe. Note: 1. You can also download the driver or check the new release at https://www.tp-link.com/download-center 2. To install driver on Linux, refer to https://www.tp-link.com/faq-2868.html 2. Select your adapter to start driver installation.
T1. What should I do if the adapter is not detected? • You could find and download the driver at https://www.tp-link.com/download-center T2. How to find the hardware version of the adapter? • The hardware version is printed on the product label on the package or the adapter.
Page 11
Network adapters, and then find the corresponding TP-Link adapter, right click it and then go to Properties; 3. If you can see “This device is working properly.” in the red box, you have already installed the driver successfully.
Page 12
FCC compliance information statement Product Name: 10 Gigabit PCIe Network Adapter Model Number: TX401 Responsible party: TP-Link USA Corporation, d/b/a TP-Link North America, Inc. Address: 145 South State College Blvd. Suite 400, Brea, CA 92821 Website: https://www.tp-link.com/us/ Tel: +1 626 333 0234 Fax: +1 909 527 6803 E-mail: sales.usa@tp-link.com...
Page 13
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
Page 14
EU declaration of conformity TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/ EU, 2011/65/EU and (EU)2015/863.
Page 16
Explanation of the symbols on the product label Symbol Explanation For indoor use only RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.