Alert Text
Data transfer cancelled
(version mismatch)
Data transfer error, please
re-transmit
Display backlight failure
Do not use for navigation
G/S has failed
(420W and 430W only)
G/S is not responding
(420W and 430W only)
G/S needs service
(420W and 430W only)
GDL 69 is not responding
GDL 88 ADS-B traffic has
failed
GDL 88 Traffic Alerting not
available
GDL 88 Connection has
been lost
GDL 88 ADS-B transmit has
failed
GDL 88 ADS-B is not
transmitting position
GDL 88 ADS-B fault - Check
GDL 88 Status Page
400W Series
Instructions for Continued Airworthiness Bell 407
Possible Cause
An attempt to transfer data during a
unit-to-unit crossfill was cancelled.
The database versions of the two
400W-series unit are not identical.
An error was detected during unit-to-
unit crossfill of user data (user
waypoints and/or flight plans).
The 400W Series unit has detected a
failure in the display backlighting.
The 400W Series unit is in Demo
Mode and must not be used for
actual navigation.
The unit has detected a failure in its
glideslope receiver.
Internal system-to-system
communication between the main
processor and the glideslope
receiver has failed. Operational
status of the glideslope receiver is
unknown.
The unit has detected a failure in its
glideslope receiver. The glideslope
receiver may still be usable.
No data is being received from the
GDL 69.
The GDL 88 is reporting that it has a
problem processing ADS-B traffic
data. The traffic picture may be
degraded.
The GDL 88 is reporting to the GTN
that the CSA application has failed.
Traffic alerting on ADS-B traffic is
unavailable.
The GNS unit cannot communicate
with the datalink
The GDL 88 is not able to transmit an
ADS-B message due to a failure with
the GDL 88 system or antenna(s)
The GDL 88 has detected a position
input fault
The GDL 88 has detected an
equipment fault
Solution
If necessary, update the
database(s) so they match.
The data transfer should be re-
attempted.
Contact Garmin technical
support.
Check that the DEMO MODE
SELECT pin, P5001 Pin 75, is
not connected.
Contact Garmin technical
support.
Contact Garmin technical
support.
Contact Garmin technical
support.
Check for proper configuration
Check wiring
Contact Garmin technical
support.
Refer to the GDL 84H/88H STC
Installation Manual.
Ensure the aircraft has a clear
view of the sky. If problem
persists contact Garmin
technical support.
Check for proper configuration
Ensure the GDL 88 is powered
up
Check wiring
Check the GDL 88 status page
in Aux mode
Refer to the GDL 84H/88H STC
Installation Manual
Refer to the GDL 84H/88H STC
Installation Manual
Check the GDL 88 status page
in Aux mode
Refer to the GDL 84H/88H STC
Installation Manual
190-01226-14 Rev. 3
Page 19 of 26