Controls And Connectors - Acer AL707 User Manual

CONTROLS AND CONNECTORS

SIGNAL CABLE
Connecting the Signal Cable: the LCD monitor comes with a built-in signal
cable. Plug the signal cable's 15-pin connector into the computer's VGA port
and tighten the two screws on the cable connector.
Connecting the Power Cord: Plug the AC-power cord into the External
Adapter. Then plug the DC-jack power cable into DC-IN Inlet.
Caution: If the AC outlet is not grounded (with three holes), install the proper
grounding adapter (not supplied).
Figure 2
1. Signal Cable
2. DC-Jack Power Cable
41L1700-786-1B 英文
Connecting Cables
3. AC Power Cord
4. External Adapter
5