1-7. Replacement of 40-pin Connector
40-pin Connector Replacement
3. Remove the two screws (_).
4. Remove the three screws and remove the connector
bracket.
P2.6 x 4
Screws (_)
5. Remove the screw securing the CN-1455 board.
6. Disconnect the two flexible card wires from the CN-
1455 board.
n
Refer to Section 1-6 before disconnecting or connect-
ing the flexible card wire.
Flexible card wire
CN-1176
1-10 (E)
P2.6 x 4
Connector bracket
P2.6 x 4
P2.6 x 4
LW2.6
CN-1455
7. Install a new 40-pin connector to the chucking plate in
the reverse procedures of removal.
8. Make sure there is a little play in the 40-pin connector.
40-pin connector
Chucking Plate Installation
9. Connect the four connectors removed in procedure 2.
10. Install the chucking plate with the six screws.
CA-755/755P