Table of Contents
Advertisement
11
Replacing the Battery
The battery must be replaced if it is no longer charged
sufficiently (avoid complete discharging). In this case,
the operational indication "Battery Failure" is gener-
ated. This indication can also be configured to one of
the 3 LEDs H1/H2/ERROR or to a relay output (see
Device Manual SICAM I/O Unit 7XV5673, order num-
ber E50417-H1040-C484).
WARNING
Warning of incorrect treatment of the lithium battery (type
PANASONIC CR2032 or VARTA 6032 101 501) or the use
of an incorrect battery type. In the case of incorrect treat-
ment or the wrong battery type, the battery may burn,
explode or trigger a chemical reaction.
See product information for type of battery to be used.
Non-observance may lead to death or serious injury.
Installing the battery or replacing it may only be carried
out by trained personnel (see preface) who are familiar
with and observe the safety requirements and precau-
tions.
Do not reverse the polarity of the battery.
Do not attempt to open the battery.
Do not attempt to recharge the battery.
Servicing of the circuitry involving the batteries and
replacement of the lithium batteries shall be done by a
trained technician.
Replace battery with VARTA 6032 101 501 or
PANASONIC CR2032 only. Use of another battery may
present a risk of fire or explosion. See manual for safety
instructions.
Caution: The battery used in this device may present a
fire or chemical burn hazard if mistreated. Do not
recharge, disassemble, heat above 100 °C (212 °F) or
incinerate.
Dispose of used battery promptly. Keep away from chil-
dren.
SICAM I/O Unit 7XV5673, Product Information
E50417-B1050-C484-A3, Edition: 03.2012
29
Advertisement
Table of Contents
