Technical Data; Operating Time; External Input; External Interface Pin Out - 3M PELTOR WS LiteCom Pro III Manual

TECHNICAL DATA

POWER
The Intrinsically safe models are powered by a rechargeable Li-ion battery pack (ACK082).
3.7 V, 1350 mAh
3.7 V, 1800 mAh

OPERATING TIME

Intrinsic safe models Expected operating time,
in power save mode, (according to standardized
measurement) in room temperature with
ACK082
Non Intrinsic safe models Expected operating
time, in power save mode, (according to stand-
ardized measurement) in room temperature with
ACK081

EXTERNAL INPUT

3M™ PELTOR™ Type J111-A
RADIO
Frequency range
Operation mode
Antenna
Channels
Channel raster
Channel spacing
Modulation
Receiver sensitivity
Output power

EXTERNAL INTERFACE PIN OUT

Pin 1
Pin 2
Pin 3
Pin 4
High power: ~12h
Medium power: ~13h
Low power: ~14h
High power: ~16h
Medium power: ~17h
Low power: ~18h
4-pole connector for external equipment
403 - 470 MHz
Half-duplex
¼ wave, integrated whip antenna
Fixed to the headset
Omni directional
Gain: 2 dBi
Up to 70 programmable channels
3.125 kHz, 6.25 kHz, 12.5 kHz, 25 kHz.
2.5 kHz and 25 kHz
Analog: Max narrow 2.5 kHz (FM), Max wide 5 kHz (FM)
Digital: 4-level FSK, 2.5 kHz max deviation.
Typical -120 dBm
High power: 200 mW e.r.p
Medium power: 20 mW e.r.p
Low power: 10 mW e.r.p
EXTERNAL PTT
Activated when shorted to Pin 2 (ground)
GROUND
INPUT
The input signal is mixed with the WS™ LiteCom Pro III Headset
audio output level (speaker output).
94 mV = Input signal level for which the mean plus one standard
deviation equals 82 dB(A) in cup.
BOOM MICROPHONE OUTPUT
Applied signal at the boom microphone input comes out on pin 4
2.25 mV Microphone input = 10 mV output