1 = Digital OUT 2 = Analog OUT2 Feedback 0 = 0-10V 1 = 0-20mA 2 = 4-20mA * If Setpoint PMW-Frequency is selected, frequency input is not avaliable at IN 2 Visit our website at Emerson.com/AVENTICS or contact us at (800) 972-2726...
If the coil current exceeds a certain value, dependent on the mechanics, for more than 20 seconds, the output current is limited to max. 70% to prevent the valve from overheating. Visit our website at Emerson.com/AVENTICS or contact us at (800) 972-2726...
4) A shielded cable must be used for protection against interference and EMC. 5) The valve body must be grounded with the earthing terminal PE (dia. M4) Visit our website at Emerson.com/AVENTICS or contact us at (800) 972-2726...
Page 6
"Parameter/Setpoint" section. The span is between +10 and +150 %. Max. outlet pressure Max. outlet pressure SHUT-OFF 50 mV 10 V 0.1 mA 20 mA 4.08 mA 20 mA Span Adjustment Visit our website at Emerson.com/AVENTICS or contact us at (800) 972-2726...
0 ... 20 mA / 4 ... 20 mA (max. 24 VDC) Digital Output: pnp; open collector; max. 200 mA/4.8W, short-circuit protected HIGH (24 VDC) if feedback=setpoint LOW (open) if feedback≠setpoint Visit our website at Emerson.com/AVENTICS or contact us at (800) 972-2726...
Supply cable 10 m; 8x0.50 mm ; straight connector TC0810MQX0000000 Supply cable 10 m; 8x0.50 mm ; right-angle connector TD0810MQX0000000 Programming cable 5 m; M12 Straight 4 Pin Male D-Coded to Male RJ45 QA0405MK0VA04000 Visit our website at Emerson.com/AVENTICS or contact us at (800) 972-2726...