Furuno WR2120 Installation Manual page 31

10. For reducing from the wind-induced movement, fasten the spring clamp above the base flange
and tighten bottom
* Do not damage the radome gasket when fasten the spring clamps.
* Use the spring clamp properly as examples shown below.
Bad examples:
Figure 5.7:
Space between spring clamp
and radome base flange
Figure 5.10:
Antenna inside radome
hex nut by hand.
Figure 5.6: Fasten properly by
Figure 5.8:
Spring clamp
spring
clamp
is
inclined
Aviod contact between the antenna
feed arm and the radome internal
flange when lifting radome top.
27
S2E-17-0209_IM_WR2120_C
Figure 5.9:
Fasten spring clamp only
partially
Approx. 330mm