Introduction; Contents - ABB SACE Emax 2 Manual

Introduction

1 - Contents

Overview This manual describes the characteristics of the Ekip Touch Trip units installed on SACE Emax 2 CBs, among
Integrated informations A full description of Ekip Touch is available in document
recipients This manual refers to two user profiles, as defined by standard IEC 60050:
Specifications and supporting
documents
Design notes The information in this manual was written in Italian and then translated into other languages to conform to
4 | © 2019 ABB | 1SDH001316R1002 - ECN000086501 - Rev. A
which:
1. general overview:
2. operating conditions
3. consultation of menus for changing parameters and displaying measurements
4. overview of protections, measurements, parameters and main accessories
5. management operations: maintenance, troubleshooting
available on the website ABB library.
• skilled person, in the electrical field (IEV 195-04-01): person with relevant education, training, knowledge
and experience to enable him or her to perceive risks and to avoid danger which electricity can create
• instructed person, in the electrical field (IEV 195-04-02): person adequately advised or supervised by
electrically skilled persons to enjable him or her to perceive risks and to avoid danger which electricity
can create
IMPORTANT: operations which can be performed by persons trained on the subject
of electricity are specifically indicated in this manual. All the remaining operations
described in this manual must be performed by skilled persons, in the field of
electricity.ABB declines all liability for damage to persons or property caused by
failure to comply with the instructions in this document.
To ensure that Ekip Touch is installed and configured correctly, please read the information in this manual and
in the technical documentation of the product, supplied with the circuit-breaker or available in the website
ABB
liBRARy
Document Description
Installation, operation and maintenance instructions for Sace Emax E1.2 CBs
1SDH000999R0002
and Ekip Dip Trip units
Installation, operation and maintenance instructions for Sace Emax E2.2-
1SDH001000R0002
E4.2-E6.2 CBs and Ekip Dip Trip units
Manual for design engineers with full information about the trip units and
1SDH001330R1002
accessories for Emax 2
1SDH001140R0001 Communication System Interface for Emax 2 CBs
1SDC200023D0906 Sace Emax 2 CBs General catalog
1SDM000091R0001 Sace Emax 2 CBs Circuit diagrams
WARNING! carefully read the instructions for putting into service and maintenance
given in the installation manuals
(for E2.2-E4.2-E6.2).
the laws and/or commercial requirements concerning the product.
1SDH001330R1002
1SDH000999R0002 (for E1.2) or
ABB | SACE Emax 2
(Emax 2 engineering manual)
1SDH001000R0002
Introduction | 1 - Contents