Table of Contents
Advertisement
74
Chapter 4
Upgrading the System
Warning! Not turning off the system properly before you start installing the
components may damage your system.
Do not attempt the procedures described in the following sections unless
you are a qualified service technician.
Postinstallation Instructions
Observe the following after installing a system component:
1.
2.
3.
4.
5.
See to it that the components are installed according to
the step-by-step instructions in their respective sections.
Make sure you have set all the required jumpers. See
"Jumpers and Connectors" on page 27 for the correct
jumper settings.
Replace any expansion boards or peripherals that you
removed earlier.
Replace the system cover.
Connect the necessary cables and turn on the system.
Advertisement
Table of Contents
