Table of Contents
Advertisement
Getting Started
Steps to Get Started
Steps to Get Started
Initial Inspection
When you receive your Agilent 81200 system inspect the container and its contents.
NOTE:
If the contents are incomplete, if there is mechanical damage or if the instrument does not pass the
selftest, notify your nearest Agilent Technologies office. Keep the shipping materials for inspection
by the carrier. The Agilent office will arrange for repair or replacement without awaiting settlement.
1 Inspect the shipping container and its contents for damage.
If the container or cushioning material is damaged, keep it until the contents of shipment have
been checked for completeness and the instrument has been verified both mechanically and
electrically.
WA RN IN G
To avoid the hazard of electric shock, do not perform electrical tests when there are signs of
shipping damage to any of the instrument's outer covers or panels.
2 Check the contents of shipment.
NOTE:
See the packing list which accompanied your system for exact details.
Determine Your System
Please use the box content list to determine your system configuration, than follow the setting up
instructions provided for that system type.
Factory pre-installed as a proprietary system, the Agilent 81200 System has the following major
configurations
• Based on the 3-slot small mainframe Agilent E4840A, see setup instructions
Agilent 81200 System based on E4840A Small Mainframe" on page 16
• Based on the 10-slot mainframe Agilent E4849B/C, see setup instructions
81200 System based on Agilent E4849B/C Mainframe" on page 20
• Based on the mainframe Agilent E4849B/C and extender frame Agilent E4848B, see setup
instructions
Agilent E4848B Mainframes" on page 24
An extended Agilent 81200 system includes up to two Agilent E4848B Expander Frames, each
equipped with an MXI/VXI Interface Card Agilent E1482B. Each Expander Frame has 12 free
slots.
The Agilent E4849B/C mainframe includes also an Agilent E1482B MXI/VXI Interface card, so
there are 9 free slots.
If the Agilent 81200 System components are ordered to be used in an open VXI system your shipment
may contain:
• at least on clock module, either an Agilent E4805A Central Clock Module or the Agilent E4831A
Clock & Data Module.
10
"Setting up an Extended Agilent 81200 System based on Agilent E4849B/C and
"Setting up an
"Setting up an Agilent
Advertisement
Table of Contents
