Step 9: Trimming The Toe Kick (Double Models Only); Step 10: Fitting The Toe Kick To The Product (Double Models Only) - KitchenAid KDDS 6010 Assembly Instructions Manual

5019_102_00273_INSTAL_GB

Step 9: trimming the toe kick (double models only)

Important!
Before cutting ensure the Toe Kick is positioned on a
wooden chopping board to avoid damage to surrounding
area.
20 On the chosen groove cut down the vertical ribs at the
centre and the ends using a knife. Cut along full length with
a knife. Turn Toe Kick over, bend and then cut from front.
Sand or scrape bottom edge to remove rough patches.
21 To avoid a cutting hazard remove all sharp edges after
trimming.
WARNING!
Remove all sharp edges
22 Remove Toe Kick tabs by snapping them off.
Step 10: fitting the toe kick to the product
(double models only)
23 Partly open bottom drawer. Position Toe Kick behind door and
slide onto the mounting rails on the underside of tub.
24 Close bottom drawer, check if flush with adjacent cabinetry. If
required open drawer and adjust.
Note: Clearance between Toe Kick and floor must be 12mm
minimum.
When Toe Kick is in position, open bottom drawer and gently
fasten the Toe Kick screws, on each side.
WARNING!
DO NOT over tighten screws. Overtightening will damage the
plastic mounting detail.
30-05-2007 13:25 Pagina 20
20
20
21
22
Toe Kick
Mounting
Rails
24
23