Table of Contents
Advertisement
Replacing light bulbs
Front turn signal lights (bulb type)
■
1
For the left side only: Pinch the clip
to remove the washer fluid filler
opening.
2
Turn the bulb base counterclock-
wise.
3
Remove the light bulb.
4
Install a new light bulb then install
the bulb base to the light unit by
inserting it and turning the bulb
base clockwise.
6-3. Do-it-yourself maintenance
After installing the light bulb, turn on the
front turn signal light to visually check that
there is no light leaking from the bulb base.
5
After replacing the left side bulb,
install the washer fluid filler opening
to its original position.
Rear turn signal lights
■
1
Open the trunk and apply protec-
tive tape to the vehicle body around
the light unit.
Use masking tape, etc. Do not use duct
tape, as it may leave residue or damage the
paint when removed.
2
Insert a flathead screw-driver
between the cover and the light unit
and pry up the cover in several
positions as shown in the illustration
to disengage the claws (indicated
by a dotted line).
To prevent scratching the vehicle, wrap the
tip of the flathead screwdriver with a cloth,
323
6
Advertisement
Table of Contents
