3Com OfficeConnect 3C886A Release Note page 9

Configuring the Client
Site
Configuring the Client
Site for a Single Modem
6 Specify the site name you would like to designate for this dial-in user's remote LAN
Modem, A, B or C. Note that this site name must be different from the site name
designated in this LAN Modem's Dial-In Global Parameters, in order to distinguish
between the two networks. The site name specified here will match the site name
configured in the client LAN Modem's Dial-in Global Parameters.
7 Click Next.
The Congratulations page opens, indicating the successful creation of a dial-in
user.
8 Click Continue.
This completes the dial-in configuration for LAN Modem Site-to-Site dial-in. To
continue setting up your LAN Modem for dial-in access, go on to "Configuring the
Client Site".
Advanced Dial-In Wizard Instructions
1 From the LAN Modem main configuration page, click Dial-in.
2 Click Dial-in Wizard.
3 Select Advanced and then click Next.
The Username and Password page appears.
4 Enter a unique name and password to identify and verify this dial-in user when
dialing into this LAN Modem.
5 Click Next.
The dial-in user parameters page appears, allowing you to manually configure the
Advanced dial-in user parameters. For further configuration instructions refer to
"Dial-in Users Parameters Screen".
To configure a dial-in user profile on the client site refer to the appropriate section:
Configuring the client site for a single modem
Configuring the client site for a LAN Modem
If the client dialing into the LAN Modem will be a single modem, use the
appropriate software such as Dial-Up Networking for Windows to create a
connection to the LAN Modem. The basic steps for creating a Dial-Up Networking
connection are as follows.
Create a Dial-Up Network entry
Enter the telephone number of the remote LAN Modem
Enter the username and password
Configuring the Client Site 9