3Com OfficeConnect 3C886A Release Note page 16

16 O C 56K LAN M
FFICE ONNECT
R N V. 7.2.0
ODEM ELEASE OTE
Figure 9 Dial-in Users Parameters Screen
3 In the Name field, enter a unique name to designate this dial-in user. This value
should correspond with the username configured on the client.
4 In the Password field, enter a password to verify access when this user dials into
the LAN Modem. This value should correspond with the password configured on
the client.
5 In the Type of Use field, select the scenario for which your dial-in situation applies.
Refer to "Understanding the Three Dial-in Scenarios" for more information.
Choose Single-User Dial-in if this user will be accessing the LAN Modem
from an analog modem or from another LAN Modem on which attached
workstations can share a single IP address.
Choose LAN Modem Site-to-Site if this user will be dialing in from another
LAN Modem which utilizes bidirectional LAN-to-LAN connectivity.
Choose Advanced if this user will be accessing the LAN Modem from a
router other than a LAN Modem. This scenario requires that all IP addresses
be statically configured, and should be configured by your MIS
administrator.
6 In the Idle Timer field, enter the length of inactivity before the LAN Modem drops
the incoming call. To disable the Idle Timer, set this field to 0. In this case all
incoming calls must be manually dropped via the LAN Modem's Manual Call
Control page. By default this value is 900 seconds (15 minutes).