Installing The Novell Netware Client Driver; Dos And Windows 3.X - 3Com Fast EtherLink 3C515-TX User Manual

3-2 C
HAPTER
Go to the section for your PC operating system in this
chapter for instructions that describe how to install the
NetWare driver on your PC.

Installing the Novell NetWare Client Driver

In a Novell NetWare environment, the network driver is
installed on a PC running one of these operating systems:

DOS and Windows 3.x

This section describes how to install the NetWare driver
for a PC running DOS or Windows 3.x. You can use the
3Com Intelligent Auto Install software program to install
the NetWare DOS ODI client software automatically,
including the driver, and to modify the CONFIG.SYS and
AUTOEXEC.BAT files.
In addition, to use the Intelligent Auto Install program,
your PC must meet these requirements:
To use the Intelligent Auto Install program, follow these
steps:
1 Make sure the 3C515-TX NIC is installed and
connected to the network as described in Chapter 2.
2 Boot the PC under DOS.
3 Insert the EtherDisk diskette in drive A and type the
following at the DOS prompt:
a:\comslink [Enter]
3: I N
NSTALLING THE
DOS
OS/2
Windows 3.x
Windows for Workgroups
Windows 95
Use the Novell NetWare 3.12 or 4.10 network
operating system
Have only one 3C515-TX NIC installed
Be intended for use as a NetWare client
N W D
OVELL ET ARE RIVER