Chapter 3. Removing The Lcd Unit - Sharp UP-600 Installation Manual

CHAPTER 3.
REMOVING THE LCD UNIT
1. REMOVING THE LCD UNIT
1) Remove the top cabinet from the bottom cabinet.
2) Remove the LCD flat cable
CKDC PWB .
3) Remove the screw and the plate
4) Remove the two screws
5
4
4
2
1
4) Remove the LCD unit from the top cabinet.
Insert a flat-bladed screwdriver into the right and left mounting
areas and remove.
and the earth wire from the
.
from the LCD HINGE .
6
3
5) With a flat-bladed screwdriver, remove the two latches of each
of the LCD rear cabinet
A
Turn of A and B when you remove it.
LCD HS unit
LCD back light
2. REPLACING THE LCD UNIT
Install the LCD unit in the reverse order of disassembly.
and the LCD filer .
LCD volume PWB