Steam For Heating Drinks; Maintenance And Daily Cleaning - Siemens TK 52 Series Operating Instructions Manual

en

Steam for heating drinks


Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts.
The appliance must be ready for use.
● Push the sleeve on the nozzle 8 all the
way up.
● Press the steam button
start to flash.
The appliance will now heat up for
i
approx. 20 seconds.
● Immerse the nozzle 8 deep into the liquid
you want to heat.
● As soon as the LED flashes, turn the
J
dial 6 to / .
g h

Risk of scalding
!
When the dial 6 is set to
may sputter a little. Escaping steam is very
hot and may cause liquid to sputter. Do not
touch the nozzle 8 or point it at anyone.
● End the process by turning the dial 6
back to "O".
T o generate more steam, press the steam
i
button again and repeat the whole
h
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is difficult
to remove.
Maintenance and daily
cleaning

Risk of electric shock!
!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
● Always remove any limescale, coffee,
milk or descaling fluid residue immedi-
ately. Such residue can cause corrosion.
● Wash all removable parts by hand only.
● Rinse out the water tank 11 with water
only.
16
● Remove, empty and clean the trays for
● Wipe out the inside of the appliance (tray
● Open the doors to the brewing unit 1
. The LED will Note: If the appliance is cold when switched
h
on, or if it is switched to "eco" mode after
dispensing coffee, it rinses automatically; in
other words the system cleans itself.
Nozzle 8 for hot water/steam
● Unscrew the nozzle 8 from the steam
● Dismantle all parts (Fig. D).
● Clean with a caustic cleaning solution and
/ , the nozzle 8
g h
● Thoroughly rinse and dry all parts.
Brewing unit
The brewing unit can be removed for
cleaning (Fig. E).
● Press the eco button to start the
● Turn the power on/off switch 1 to 0.
● Open the door 1 to the brewing unit .
● Hold the red button a down and push
● Grasp the brewing unit  by the handle,
● Vacuum the inside of the appliance, or
● Reinsert the brewing unit  all the way
● Hold the red button a down and push
● Close the doors of the brewing unit.
coffee grounds 17 and residual water 18.
holders).
and remove any coffee residues. Close
the doors.
pipe.
a soft brush. Clean the tip of the nozzle
8/c with a blunt needle.
automatic rinse cycle.
the handle b up until you hear it
engage.
remove carefully, and rinse under running
water. Do not use cleaning agents. Do not
place in the dishwasher.
clean it with a damp cloth.
into the appliance.
the handle b down as far as it goes,
until you hear it engage. The brewing unit
is now secure.