Preparing Hot Water - Siemens TK 52 Series Operating Instructions Manual

Reset: Switch the appliance to "eco"
mode and remove trays 17 and 18. Press
and hold the dispensing buttons
simultaneously for at least 5 seconds.
K
The LEDs 7a, b, c and d (
light up briefly. Replace the trays 17 and
18 and press the button eco to switch the
appliance on again.

Preparing hot water

The appliance must be ready for use.
This function allows water to be heated for
a cup of tea, for example.

Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts.
● Place an appropriate cup under the
nozzle 8.
● Push the sleeve on the nozzle 8 all the
way down.
● Turn the dial 6 to
g

Risk of scalding
!
When the dial is set to
may sputter a little. Do not touch the nozzle
8 or point it at anyone.
● End the process by turning the dial 6
back to "O".
Important:
For safety reasons it is not possible to
dispense hot water when the appliance is in
"eco" mode. First press the eco button and
then dispense hot water.
and
5
, , , )
H I S J
/ .
h
/ , the nozzle
g h
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk first and add the coffee
on top, or foam the milk separately and
pour it into the coffee.

Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts.
● Push the sleeve on the nozzle 8 all the
way down.
● Fill the cup approximately 1/3 full of milk.
● Press the steam button
start to flash.
The appliance will heat up for approx.
i
20 seconds.
● Immerse the nozzle 8 deep into the milk,
but do not let it touch the bottom of the
cup.
● As soon as the LED flashes, turn the
J
dial 6 to / .
g h

Risk of scalding
!
When the dial 6 is set to
8 may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle 8 or point it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial 6
back to "O".
T o foam more milk, press the steam
i
button again and repeat the whole
h
process.
Note: When the nozzle 8 has cooled
down, clean it immediately. Dried residue is
difficult to remove.
Tip: If possible, use cold low-fat (1,5% fat)
milk.
en
. The LED will
h
/ , the nozzle
g h
15