Troubleshooting; Basic Connection Checks - 3Com 3CRWER300-73 User Manual

6
Basic Connection
Checks
T
ROUBLESHOOTING
The Router has been designed to aid you when detecting and solving
possible problems with your network. These problems are rarely serious;
the cause is usually a disconnected or damaged cable, or incorrect
configuration. If this section does not solve your problem, contact your
supplier for information on what to do next.
Perform these actions first:
Ensure all network equipment is powered on.
■
Power each piece of network equipment off, wait about five seconds
■
and then power each one on.
CAUTION: Do not power the Router off and then immediately on. Wait
about five seconds between power cycles.
Check the following symptoms and solutions:
Check that the Router is connected to your computers and to the
■
cable/DSL modem, and that all the equipment is powered on. Check
that the LAN Status and power LEDs on the Router are illuminated,
and that any corresponding LEDs on the NIC are also illuminated.
Ensure that the computers have completed their start-up procedure
■
and are ready for use. Some network interfaces may not be correctly
initialized until the start-up procedure has completed.
If the link status LED does not illuminate for a port that is connected,
■
check that you do not have a faulty cable. Try a different cable.
Port Status LED not lit for a port that has a TP cable connected. After
■
connection, it may take several seconds for the Port Status LEDs to
illuminate. The Port Status LED should turn Blue, for each port that is
connected. If the Port Status LED is not lit after several seconds, ensure
that the connected device is powered on, that the TP cable is not